First I'll list problems/cons:
ONE BIG PROBLEM: The manual is wrong for torque! The correct values are: For 1/4 the torque is 8 to 10 ft-lb, for 3/8 the torque is 15 to 18 ft-lbs. The manuals says ridiculous values (47 ft-lbs!?) that are likely to destroy your nuts. See the attached photo.
The factory flare was junk on the 1/4. I recommend re-flaring everything and this is typical advice for mini splits lines. See the photo.
Last issue: I couldn't figure out how to pair the phone. It's in the quick guide, not the main instruction manual. Hit "Display" on the remote 6 times for the unit to enter pairing mode.
Outside is very quiet, the inside is a little louder than some other units, but it's still quiet on the lowest fan speed. The inside could be quieter though, but I'm fussy when it comes to noise. It's much quieter than any window unit or normal AC.
Pros/Good and expository:
I've installed many mini splits. This install was good! I know what to look out for so it went off without a any major holdups.
The instructions are great, and the quick guide is well done. I didn't even notice the quick guide until I was done.
The app seems to work better than the remote. So far five stars on the app.
For newbies, I like to mention what you'll need:
- A vacuum pump for the lines and mini-split adapter (usually about $110 here on Amazon). When you vacuum, it should eventually be dead silent and not make "hiccup" noises. If it does, you have a leak and need to tighten or re-flare. Every mini-split I've installed, except one, I have needed to re-flare at least one connection. Because you might need to re-flare, be sure to leave a little slack.
- Flaring tool. From Amazon they are well priced (I recently bought one for less than $30) Search for "Forsun flaring tool"
- I have a digital torque wrench, but they're expensive. A normal torque wrench also works. You can also just eyeball it, but if this is your first time, you'll not know how tight.
- I use Nylog because I was told to, but I honestly don't know if it truly makes a difference.
- Electrical: Take note! A 110 is not a 230, know what you're installing I typically run the lines myself and the parts aren't too expensive. Buy an AC whip and a disconnect, both can be bought on Amazon.
- Mini-split wall brackets. Especially for the winter when snow may bury the unit, you want it off the ground at least a bit. I bought the Turbro bracket with cross bars for easier install and it seems to be great quality.
- Mini split line cover set. There's many good ones, the name brand ones are best but more expensive. Turbro sells one that appears to look fine.
- Hole saw. I have a whole bunch in my garage. You can buy affordable kits on Amazon.
And other normal tools (wrench, drill, screw driver, screws for the bracket, etc.)
Overall, seems to be working great. Heat works very well, cools great. Overall, well done Turbro.